Agria 6000 - Engine; Operation on Slopes

14 Power Hoe 6000 Edition 11.98
2. Specifications
Engine
Manufacturer:.............................. agria
Type: .................................... 66/6 or 1*
Version: ........................ Fan-air-cooled
1-cylinder-2-stroke engine (petrol)
Lubrication: ............. Petroil lubrication;
stoichiometric ratio 1:30
Bore: ........................................ 56 mm
Stroke: ..................................... 58 mm
Cubic capacity: ..................... 150 ccm
Compression: .............................. 6 :1
Output: .................................... 4.8 kW
at 4500 rpm
Spark plug: ..................... Bosch M10A
Spark plug gap ................ 0.5…0.6 mm
Ignition system: ................... Flywheel
magnet ignition
Contact clearance ....... 0.35…0.45 mm
Ignition point ............... 2.5 before u.d.c.
radio remote screened according to
VDE 0879
Starter:........................... Recoil starter
Stop device: ................. Contact break
via short circuit cable
Engine-stop-switch on handlebar
Generator: .............................. 6V A.C.
Fuel tank capacity: ......... approx. 4.5 l
Fuel: ..................................Commercial
petrol/oil mixture 1:30
octane number min. 90 RON
and self-mixing
supergrade 2-stroke engine oil, e.g.
Shell: Super T, Super TX;
Esso: Exxon Special 2T Engine oil;
BP: 2T Special
(refer to fuel recommendations)
Air filter: .....................Oil bath air filter
Engine oil filling
quantity: ......................... approx. 150ml
Carburetor:...... Piston slide carburetor
Bing 1/18/31 or 1/18/106
Air control screw: ....... in basic setting
approx. 1/2…1 1/2 revs. open
Main jet: .......................................... 95
Idle jet: ............................................ 45
Needle jet: .................................. 1108
Needle setting: ................................. II
Rated speed: ....................... 4800 rpm
Top no-load speed: ............. 6300 rpm
Idling speed: ....................... 1800 rpm
Operability on Slopes:
Engine is suited for use on slopes:
continuous operation possible
up to .................. 45° inclination (100%)