Agria 6000 - Hoeing

26 Power Hoe 6000 Edition 11.98
4. Commissioning and Operation
Hoeing
l Start the engine as described in “Start-
ing the Engine”.
l Pull hand clutch lever (C/5).
l Select proper speed with gear shift
lever (A/3).
For heavier soil and coarse tilling:
– select slow speed “I”.
For lighter soil and medium tilling:
– select medium speed “II”.
For sandy soil and fine tilling:
– select fast speed “III”.
l Slowly release hand clutch lever while
pressing the throttle – the power hoe
moves forward and hoeing tools start
working.
End of Hoeing
l Move speed control lever to idling po-
sition.
l Pull hand clutch lever and hold.
l Move gear shift lever to position “0”
(neutral).
I
Before you actuate the shift
lever, pull hand clutch lever
to stop. Only move the shift le-
ver with your hands.
Change of work-site
l Turn off the engine.
l Pull hand clutch lever.
l Turn off hoeing drive (B/19) (position
“0”).
l If present, fold front support wheel into
travel direction.
Hazardous area
W
Staying in the hazardous area
of the power hoe is not per-
mitted when the power hoe is
being started or in operation.
W
Never leave the operator’s
position at the steering han-
dle while the machine is at
work.
During all operation with the power
hoe, especially when turning, the
operator must keep at a safe distance
as defined by the steering handle.
Do not clean hoeing tools with the en-
gine running. Switch off the engine
and remove spark plug connector.
If clogging occurs, turn off the engine
and clean the attachment with an ap-
propriate tool (wooden stick).
4227
Hazardous area