System settings (Settings (Table View))
125
I-picture interval [H.264 / AVC] ♦ (Video Door Station only)
Bit rate [kbps] [H.264 / AVC] (Video Door Station only)
Select Quality [Motion-JPEG] (Video Door Station only)
RTP Start Port ♦ (Master Station and Video Door Station only)
RTP End Port ♦ (Master Station and Video Door Station only)
Description Set the interval for transmitting pictures with H.264 / AVC.
Settings 1-100
Default values 15
Description Select the bit rate for H.264 / AVC.
Settings 64, 128, 256, 384, 512, 768, 1024, 2048 kbps
Default values 1024 kbps
Description Set the image quality of Motion-JPEG.
Settings 1 (Low) through 10 (High)
Default values 6
Description Set the start port for the RTP communication range.
The (RTP End Port) should be greater than 90 digits from the (RTP Start Port). If a
smaller range is set, in some cases ports outside the range will still be used.
Settings 1-65534
Default values 30000
Description Set the end port for the RTP communication range.
The (RTP End Port) should be greater than 90 digits from the (RTP Start Port). If a
smaller range is set, in some cases ports outside the range will still be used.
Settings 1-65535
Default values 31000
To Next Page
Loading...