Introduction
14
Introduction
5. Configuring the system
After installing and connecting all stations, the system will need to be fully configured before it
will be operational.
IX system can be configured in one of the two methods below. Choose one method. Using the
IX Support Tool is the recommended method.
(1) Configure the system using the "IX Support Tool" application
Install the application on a PC and use to create the configuration for all stations.
Search for IX stations on the network; assign and upload configuration data for the system.
Monitor the system for failures.
(2) Configure each station through a Web browser (WEB Settings Access)
Access each station through a Web browser, and configure each station individually.
When using the Web browser method, each station must be configured separately.
When configuring the system through a browser, the IX Support Tool cannot be used.
For more detail, refer to Web Setting Manual for each station.
Once the system has been configured through a browser, the settings cannot be
transferred to the IX Support Tool. Using the IX Support Tool is the recommended
method to manage settings.
If the settings configured with IX Support Tool are altered through a browser, some
items may not be correctly updated within the IX Support Tool data.
Save the settings after configuring the system.
To Next Page
Loading...