System settings (Settings (Table View))
163
2) Click , the following window will be shown. Select the destination station to be
released when the station selected in 1) operates the door release, and click .
When the station selected is the destination station
3) Only the door release operating tone will be set up. (If the selected station is Master Station,
only "None")
The settings configured in "Door Release Operating Tone" ➤ P.159 will be shown.
Choose the door release operating tone in the pull-down menu, and change the setting.
• When the setting is changed, the settings configured in "Door Release Operating
Tone" ➤ P.159 will be changed as well.
Configure the authentication key.
The settings configured in "Authentication Key" ➤ P.160 will be shown. Enter the
authentication key and change the setting. The configured authentication key will be copied
to the key.
• When the setting is changed, the settings configured in "Authentication Key" ➤ P.160
will be changed as well.
When the station selected is the originating sation
3) Select the destination station when the door connected to the originating station is to be
released.
To Next Page
Loading...