Introduction
17
To change the Settings (For Static IPv4 Address)
Use flowchart to change the settings.
1. Set "Language."
"3. Language" ➤ P.95
2. Retrieve the setting data for all the stations.
"1.4. Download Settings From Station" ➤ P.83
3. Configure the station.
"System settings (Settings (Table View))" ➤ P.107 "System settings (Settings (Station View))" ➤ P.200
4. Disassociate the settings of the
station whose IP Address was
changed, and associate it again.
"4.2. Association Settings" ➤ P.97
The station will be restarted, and "IP Address" will be
registered in the station.
4. Upload the
setting data to all
the stations.
"1.5. Upload Settings To
Station" ➤ P.85
4. Upload the
setting data to
the station
whose settings
were changed.
"1.5. Upload Settings To
Station" ➤ P.85
5. Upload the setting data to all the
stations.
"1.5. Upload Settings To Station" ➤ P.85
5. Done. 5. Done.
6. Done.
Has the "Number,"
"Name," "Location," "IP Address,"
"Location Registry," or "Camera name" been
modified?
To Next Page
Loading...