Introduction
28
For Static IPv6 Address
Create new data
Use flowchart to create new configuration, e.g., when installing a new system.
1. Set "Language."
"3. Language" ➤ P.95
2. "New System."
"1.1. Create New System" ➤ P.81
3. Configure using "Settings (Table View)."
Configure the station according to the description of each item. "System settings (Settings (Table
View))" ➤ P.107
4. Install all stations.
Note the MAC addresses of all the stations.
5. Associate the created setting data to each station.
"4.2. Association Settings" ➤ P.97
6. Choose "IPv6" for the communication method of IX Support Tool.
"2.10. IX Support Tool Settings" ➤ P.93
7. Upload the setting data to all the stations.
"1.5. Upload Settings To Station" ➤ P.85
8. Set the clock of each station.
"1.3. Time" ➤ P.113
9. Set "LANGUAGE" of each Master Station.
Refer to IX Master Station Operation Manual.
10.Done.
To Next Page
Loading...