Save the settings after configuring the system.
Refer to "Where the setting file is saved" ➤ P.82.
If the setting file is lost, station settings will need to be reconfigured.
1. Set "Language."
"3. Language" ➤ P.95
2. Retrieve the setting data for all the stations.
"1.4. Download Settings From Station" ➤ P.83
3. Choose "IPv4" for the communication method of IX Support Tool.
"2.10. IX Support Tool Settings" ➤ P.93
4. Add the setting data.
" System settings (Settings (Table View))" ➤ P.107
First, add the station data to "1. Station Information" ➤ P.108.
5. Install the station to be added.
Note the MAC addresses of all the stations.
6. Associate the setting data to the added station.
"4.2. Association Settings" ➤ P.97
7. Choose "IPv6" for the communication method of IX Support Tool.
"2.10. IX Support Tool Settings" ➤ P.93
8. Upload the setting data to all the stations.
"1.5. Upload Settings To Station" ➤ P.85
9. Set the clock of the added station.
"1.3. Time" ➤ P.113
10.Set "LANGUAGE" of the added Master Station.
Refer to IX Master Station Operation Manual.
11.Done.
To Next Page
Loading...