Save the settings after configuring the system.
Refer to "Where the setting file is saved" ➤ P.82.
If the setting file is lost, station settings will need to be reconfigured.
1. Set "Language."
"3. Language" ➤ P.95
2. Retrieve the setting data from the station to
be replaced.
"1.4. Download Settings From Station" ➤ P.83
2. Replace the station.
Note the MAC address of the station to
be replaced.
3. Replace the station.
Note the MAC address of the station to be replaced.
3. Change "IP addressing
method" to "Static IPv6" for
the newly installed station
and configure an
appropriate "IPv6 Address."
To configure a station through a Web
browser, refer to Web Setting Manual for
each station.
4. Change "IP addressing method" to "Static
IPv6" for the newly installed station and
configure an appropriate "IPv6 Address."
To configure a station through a Web browser, refer to Web
Setting Manual for each station.
4. Replace the setting data.
* If the settings are modified after being
restored, those changes will not be
reflected.
"4.3. Station Replacement" ➤ P.99
5. Replace the setting data.
"4.3. Station Replacement" ➤ P.99
6. Set "LANGUAGE" of the replaced Master
Station.
Refer to IX Master Station Operation Manual.
5. Set "LANGUAGE" of the
replaced Master Station.
Refer to IX Master Station Operation
Manual.
7. Done. 6. Done.
To Next Page
Loading...