19 1800223 E
5. With the concentration adjusted to the desired
level, the aerosol output can be switched on
and off as needed by using the Power Switch.
6. When switching off the generator, aerosol in
the generator tank will continue to dissipate out
for a short period of time
7. Turning ON the Aerosol Switch will restart
aerosol production at the previous setting.
Note
Optionally, the tip of the pressure gauge’s rubber vent seal may be
clipped with a knife or scissors prior to use. (Refer to Chapter 6 for
directions on this procedure.) This will eliminate the small drift in
pressure readings that occurs with sealed gauges as the 6D unit warms
with continuous, extended use. Venting the gauge may be
advantageous if pressure settings must be precisely monitored or
adjusted during extended run times.
Venting should not be necessary for most users. Pressures set during
initial use will remain accurate and steady for the remaining duration
regardless of any small changes in pressure readings
The 6D unit must remain upright if the vent seal is trimmed, or the
glycerin liquid filling the gauge will leak out
To Next Page
Loading...