Aircel AHLD E-Series - Page 33

Heatless Regenerative Desiccant Air Dryer | AHLD Series
33
6 . Accidental release measures
Cleanup:
Vacuum up spilled product
.
Place into suitable container for disposal
.
7 . Handling and storage
Handling
General advice:
Avoid dust formation in confined areas .
Avoid contact with the skin, eyes and clothing
. Ensure adequate
ventilation
.
Storage
General advice:
Keep container tightly closed in a cool, well-ventilated place
.
Storage stability:
Keep container dry.
8 . Exposure controls and personal protection
Components with workplace control parameters
Aluminum oxide (Al2O3),
OSHA
PEL 5 mg/m3 Respirable fraction ; PEL 15 mg/m3 Total
hydrate
dust ;
ACGIH
TWA value 1 mg/m3 Respirable fraction ;
Safety data sheet
F200
Revision date : 2008/12/04
Version: 3.0
Page: 2/5
(30286124/MDS_GEN_US/EN)
If on skin:
After contact with skin, wash immediately with plenty of water and soap
. Consult a doctor if skin irritation
persists .
If in eyes:
In case of contact with the eyes, rinse immediately for at least 15 minutes with plenty of water
. Immediate
medical attention required
.
If swallowed:
No hazards anticipated . If large quantities are ingested, seek medical advice.
5 .
Fire-fighting measures
Flash point:
Additional information:
Use extinguishing measures to suit surroundings
.
Hazards during fire-fighting:
No particular hazards known .
Non-flammable.
Protective equipment for fire-fighting:
Wear self-contained breathing apparatus and chemical-protective clothing .
NFPA Hazard codes:
Health : 0 Fire: 0
Reactivity: 1
Special:
APPENDIX
Desiccant Material Safety Data Sheet