How to fix pattern too narrow from AIRLESSCO SL810?
If the spray pattern from your AIRLESSCO Paint Sprayer is too narrow, it's likely the spray angle is too small. Use a larger spray angle tip. If coverage is okay, try a tip in the same nozzle group.
Why are there craters or pock marks on work with AIRLESSCO SL810?
Craters, pock marks, or bubbles appearing on your work with the AIRLESSCO Paint Sprayer can be due to solvent balance issues. Use 1 to 3% “short solvents remainder “long” solvents. This is most likely to happen with material of low viscosity, lacquers, etc.
Medical alert for fluid injection injuries, emphasizing emergency care and physician notification.
High pressure fluids can penetrate skin, causing extreme injury, including amputation.
Keep area clear and ventilated, no flammable material or ignition sources.
Safety guidelines for gun operation, including tip guard and pressure relief.
Guidelines for checking, using, and maintaining high-pressure fluid hoses.
Ensure components have adequate pressure rating; follow pressure relief procedures.
Ground equipment, keep sprayer away from spray area, avoid plugging cords.
Serious injury or death from hazardous fluid/fumes. Know fluid hazards and use PPE.
Grounding sprayer and components to reduce static sparking risk.
Specific safety precautions for flammable materials, including ventilation and grounding.
Keep clear of moving parts to avoid amputation or burns.
Safety warning and instructions for grounding the sprayer and system components.
Step-by-step guide to starting the sprayer for operation.
Engage the gun safety latch as per the gun's manual.
Disengage safety latch and trigger gun to relieve pressure.
Open the Prime/Pressure Relief Valve to relieve remaining pressure.
Re-engage safety latch and close the Prime/Pressure Relief Valve.
Table listing common spray defects, their causes, and recommended corrections.
Troubleshooting steps for a unit that fails to prime.
Troubleshooting steps for low or no pressure after priming.
Troubleshooting steps for maintaining consistent spraying pressure.
Troubleshooting steps for a unit that does not run.
Verify control settings, circuit breaker, power source, and thermal overload.
Test motor brushes, sensor resistance, and thermal coupler continuity.
Test potentiometer and pressure control assembly for proper function.
Procedure to calibrate the zero point of the pressure display.
Procedure to calibrate the pressure reading against a gauge.
General| Brand | AIRLESSCO |
|---|---|
| Model | SL810 |
| Category | Paint Sprayer |
| Language | English |
To Next Page