SPX+ Introduction Manual - updated until firmware 4997
- 75 -
Offline a sensor
You can manually offline any sensor by clicking on the green Online button on the sensor’s
configuration page.
You’ll be asked for confirmation in a popup window.
Note: if you change a sensor to “offline” it will no longer be displayed on the web interface. In order to
reactivate it, you have to toggle it back to “online”.
Smart Sensor Recovery
This feature will be used only for the new Smart Sensor type. The firmware can be updated on these
sensors automatically, and if the upgrade has failed for some reason and the sensor becomes
unresponsive, with this option you can recover them to the default firmware. It’s not used by other
sensor types.
Note:
If there's a difference between the version
stored in the unit's firmware and the sensor’s
firmware, it will upgrade/downgrade the
sensor’s firmware upon powering up/reboot of
the unit, or on sensor reconnection.
If you need to downgrade the smart sensor
firmware, you can only do so together with the
unit’s firmware.
To Next Page
Loading...
Need help?
General
