EasyManuals Logo

AKCP SP+ Series Introduction Manual

Default Icon
98 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
SPX+ Introduction Manual - updated until firmware 4997
- 76 -
Change Continuous Time
The following advanced functions are for setting the time frame in which the system should delay a
notification being triggered when a sensor gives a reading that exceeds the thresholds (high warning,
normal, etc).
Continuous Time to Report High Critical: This helps to eliminate unnecessary messages during minor
fluctuations. You can set the amount of time to delay a notification of a status change from high
warning to high critical. Enter the time in seconds and press the “Save” button. The amount of time
that can be entered is between 0 and 65535 seconds which equals approximately 18 hours.
Continuous Time to Report High Warning: As above but delays notification for “High Warning”.
Continuous Time to Report for Normal: As above but delays notification for return to “Normal” state.
Continuous Time to Report for Low Warning: As above, but delays notification for “Low Warning”
state.
Continuous Time to Report for Low Critical: As above but delays notification for “Low Critical” state.
Continuous Time to Report for Sensor Error: As above, but delays notification being sent for sensor
going into an error state.
Example: An airflow sensor or humidity sensor may have temporary drops in readings which are
normal operating characteristics; a logical time limit is set to show abnormal conditions.

Other manuals for AKCP SP+ Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AKCP SP+ Series and is the answer not in the manual?

AKCP SP+ Series Specifications

General IconGeneral
BrandAKCP
ModelSP+ Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals