Page 5 of 68
Figure 24-showing socket orientation ............................................................................... 34
Figure 25-Switch and LED side of Controller Board ....................................................... 35
Figure 26-Bending the IR Detector Leads and setting the mounting height .................... 36
Figure 27-LED with white spacer added .......................................................................... 37
Figure 28-Completed controller, push-button and LED side and component side........... 38
Figure 29-Silkscreen side of the Input Selector Board shows component locations ........ 41
Figure 30-Align socket feature with silk screen ............................................................... 44
Figure 31-Mounting the input connector shield................................................................ 47
Figure 32-Assembled Input Selector board ...................................................................... 48
Figure 33-Insert opamp so semi-circular indentation in IC package matches silk-screen
feature ............................................................................................................................... 51
Figure 34-16 pin ribbon cable orientation and installation ............................................... 52
Figure 35-Silkscreen side of the Tone Volume Board shows component locations ........ 54
Figure 36-Remember to match silk screen and IC orientation mark ................................ 57
Figure 37-Identify pin 1 for proper connector installation ............................................... 58
Figure 38-Motor POT wire preparation ............................................................................ 58
Figure 39-Motor POT wiring detail .................................................................................. 59
Figure 40-Completed Tone/Volume Board ...................................................................... 60
Figure 41-Connecting wires to front panel (FP) 1/8" phono jack ..................................... 60
Figure 42-Inserting 1/8" jacks in the front panel .............................................................. 61
Figure 43-Showing 10 pin Ribbon Cable Installation and Orientation ............................ 63
Figure 44-Install plastite screws (6) in the holes between the left and right channel input
jacks .................................................................................................................................. 64
Figure 45-Two of the three cover plates have been installed ........................................... 64
To Next Page
Loading...
