AkitikA PR-101 - Section 3: Building the Power Supply PCB; Component Order; Figure 1-Empty the Power Supply Components into a Soup Bowl; Figure 2-Component Side of Power Supply PCB before Loading

Page 9 of 68
Section 3: Building the Power Supply PCB
This section details the process of building the power supply circuit board. Begin by
carefully emptying the contents of the envelope marked “PR-101 Power Supply” into a
broad soup bowl, as shown below. In general, you’ll start with the components that lay
closest to the board, working your way towards the taller components.
Figure 1-Empty the power supply components into a soup bowl
Component Order
Figure 2-Component side of power supply PCB before loading