Akuvox IT83 Series - Intercom Call Configuration; IP Call & IP Call Configuration

Android Indoor Monitor Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
48
11. Intercom Call Configuration
11.1.IP call & IP Call Configuration
IP calls and SIP calls can be made directly on the intercom device by entering
the IP number on the device. And you can also disable the direct IP call if you
allow no IP call to be made on the device. To configure the IP call feature and
port on the device web Phone > Call Feature > Others interface.
Parameter Set-up:
 Direct IP Call: tick the check box to enable the direct IP call. For example,
if you do not allow direct IP call to be made on the device, you can untick
the check box to terminate the function.
 Direct IP Call Port: the direct IP Call Port is "5060" by default with the port
range from 1-65535. And you enter any values within the range other
than the 5060, you are required to check if the value entered is consistent
with the corresponding value on the device you wish to establish a data
transmission with.