Akuvox IT83 Series - Configure Alarm Action Via HTTP Command

Android Indoor Monitor Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
82
Parameter Set-up:
 HTTP Command: enable HTTP command if you want the action to be
implemented on a designated third party device
 SIP Message: enable SIP message if you want the SIP message to be
sent to a designated SIP account as an action
 Call: enable Call if you want you a call to go to a designated SIP or IP
number.
14.2.7.2. Configure Alarm Action via HTTP Command
To set up the HTTP Command action, you can click “Enable”in the Send HTTP
field to enable the actions for the alarm sensor installed in different locations.
Then enter the HTTP command provided by the manufacturer of the device
on which the action is to be carried.