Android Indoor Monitor Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
Remote Control: enable it to trigger local relay by DTMF and vice versa.
15.1.2. Remote Relay Switch Setting
You can use the unlock tab during the call to open the door on web Phone >
Relay > Relay Setting > Remote Relay interface. You are required to set up
the same DTMF code in the door phone and indoor monitor.
Parameter Set-up:
DTMF Code: To set DTMF code for the remote relay, which is “#” by
default.
15.2.Web Relay Setting
In addition to the relay that is connected to indoor monitor, you can also
control the door access using the network-based web relay. To do this
configuration on web Phone > Relay > Web Relay interface.
To Next Page
Loading...