Android Indoor Monitor Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
the door access. To do this configuration on web Intercom > Relay > Open
Relay Via HTTP interface.
Parameter Set-up:
Status: Enable it to allow the relay to be triggered remotely using HTTP
command.
Username: Enter the device username to be used as a part of HTTP
command to trigger the local relay.
Password: Enter the device password to be used as part of HTTP
command to trigger the local relay.
Please refer to the following example:
http://192.168.35.127/fcgi/do?action=OpenDoor&UserName=admin&Passw
ord=12345&DoorNum=1
Note:
DoorNum in the HTTP command above refers to the relay number
#1 to be triggered
To Next Page
Loading...