Customization
• Auto – backlight is automatic - will activate as soon as you use
any command, and will deactivate approximately 20 seconds
after the last command is given.
• Off – backlight deactivated
4) Press the
button repeatedly until the desired setting is se-
lected.
5) Exit the sub-menu by pressing the F4/ESC button, then press it
a second time to exit the main menu and return to the standby
screen.
8.4 Exclusion of internal speaker
If your transceiver is connected to an (optional) external speaker, you
may wish under some conditions to use only the external speaker,
and exclude the internal one. To do this:
1) Press the
button to access the command menu, then use the
buttons to highlight the Radio Param. option.
2) Press
to view the sub-menus available.
3) Press the
buttons until the Int.Spkr Off (deactivation
of internal speaker) sub-menu is highlighted.
4) Press
to insert the symbol beside the appropriate option.
(In other words, so the internal speaker is deactivated.)
5) Exit the sub-menu by pressing the F4/ESC button, then press it
a second time to exit the main menu and return to the standby
screen
To reactivate the internal speaker, follow the above procedure
and, at Step 3, press
to delete the symbol.
Do not disconnect the external speaker when the internal one
is deactivated. You may damage the radio.
To Next Page
Loading...
