Advanced functions
4) Press
to insert the symbol. The audio amplifier will be acti-
vated, and the
icon will appear on the display.
5) Exit the sub-menu by pressing the F4/ESC button, then press it
a second time to exit the main menu and return to the standby
screen.
At this point, each time you press the PTT transmission button, in-
s
tead of transmitting, your voice transmission will be heard on the
external speaker.
To reactivate normal radio functions, repeat the above procedure, re-
m
oving the
symbol in step 4.
Once you have finished using the PA, do not forget to reactiva-
te your radio’s normal functions.
A faulty connection to the external speaker may seriously da-
mage the transceiver.
10.8 Auxiliary output
The rear Input/Output socket of the radio can control external de-
vices that are activated/deactivated each time you turn your device
on/off. To activate this function:
1) Press the
button to access the command menu, then use the
buttons to highlight the Switches option.
2) Press
to view the available sub-menus.
3) Press the
buttons repeatedly until the Aux.Out sub-
menu is highlighted.
4) Press
to insert the symbol. The auxiliary output will be ac-
tivated, and the
icon will appear on the display when the device
is in standby.
5) Exit the sub-menu by pressing the F4/ESC button, then press it
a second time to exit the main menu and return to the standby
screen.
To reactivate normal radio functions, follow the procedure outlined
above.
A faulty connection to the Input/Output socket may seriously
damage the transceiver.
10.9 External alarm
You can program your radio so that, each time you receive a valid se-
lective call, external devices are activated (e.g., an acoustic alarm to
advise you of an incoming call if you are away from your vehicle) using
a suitable contact with the rear Input/Output socket on the radio. To
activate this function:
1) Press the
button to access the command menu, then use the
buttons to highlight the Switches option.
2) Press
to view the available sub-menus.
3) Press the
buttons repeatedly until the Alarm (auxiliary ou-
tput) sub-menu is highlighted.
4) Press
to insert the symbol. The auxiliary output will be acti-
vated, and the
icon will appear on the display when the device
is in standby.
5) Exit the sub-menu by pressing the F4/ESC button, then press it
a second time to exit the main menu and return to the standby
screen.
A faulty connection to the Input/Output socket may seriously
damage the transceiver.
To Next Page
Loading...
