...................................................................................................................................................................................................
7
Grasp the card by the open latch and slide the card out of the slot, being careful not to pull
on any connected fibers on the NE. You will encounter some resistance while the card is
seated on the backplane. Use a gentle pulling force to unseat the card from the backplane.
Slide the card out of the slot. When the card is almost removed, place a hand under the
card to avoid dropping it when it is fully removed from the shelf.
...................................................................................................................................................................................................
8
Place the card in an ESD bag and set it aside nearby so that you can immediately continue
with Step 9.
...................................................................................................................................................................................................
9
Grasp replacement card with one hand on the faceplate and the other on the bottom of the
card's PCB.
...................................................................................................................................................................................................
10
Align the card's PCB with the card guides.
...................................................................................................................................................................................................
11
Slide the card along the card guides into the slot. When the card is partially inserted,
grasp the card by the latch, with the latch in the open position.
...................................................................................................................................................................................................
12
Ensure that no fibers from adjacent cards are in the way, and slide the card into the slot.
You will encounter some resistance when the card contacts the backplane. Use gentle
force to fully seat the card on the backplane.
...................................................................................................................................................................................................
13
Lock the card into place by closing the latches. As the latches close, they push against the
latching tabs on the shelf or cross member, further seating the card. Continue to close the
latches until they are flush with the card faceplate, locking the card in place.
...................................................................................................................................................................................................
14
Set the fan back to normal speed.
CLI config fan normal
WEBUI FAN > Card Properties > Fan Speed > Normal
...................................................................................................................................................................................................
15
Once the port LEDs on the card have lit up, uncap, clean, and reconnect the fibers.
Supporting procedures
Replacing System Components
Replacing a Card (General)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
3-23
To Next Page
Loading...
