Alcatel-Lucent 7330 - DLP 1174 - Create an xDSL IPoA user and add this user to a VLAN on the LT for C-VLAN cross-connect; DLP 1182 - Configure SHDSL; DLP 1183 - Configure IMA on SHDSL spans; DLP 1187 - Configure global VLAN parameters on the LT

ETSI ONT safety guidelines
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 xi
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
Figure 1 PSE certification
Safety standards compliance
This section describes the ONT compliance with the European safety standards.
EMC, EMI, and ESD compliance
The ONT equipment complies with the following EMC, EMI, and ESD
requirements:
• EN 300-386 V1.3.2 (2003-05): Electromagnetic Compatibility and Radio
Spectrum Matters (ERM): Telecommunications Network Equipment;
Electromagnetic Compatibility (EMC) requirements; Electrostatic Discharge
(ESD) requirements
• EN 55022 (1998): Class B, Information Technology Equipment, Radio
Disturbance Characteristics, limits and methods of measurement
• EN 55024 (1998): Information Technology Equipment, Immunity
Characteristics, limits and methods of measurement
• European Council Directive 2004/108/EC
• EN 300-386 V1.4.1: 2008
• EN 55022:2006 Class B (ONTs)
• EN EN 61000-3-2:2006
• EN EN 61000-3-3:2008
• IEC 61000-4-2:2001
• IEC 61000-4-3:2006
• IEC 61000-4-4:2004
• IEC 61000-4-5:2005
• IEC 61000-4-6:2003/A1:2004/A2:2006
• IEC 61000-4-11:2004
Equipment safety standard compliance
The ONT equipment complies with the requirements of EN 60950-1, Safety of
Information Technology Equipment for use in a restricted location (per R-269).
This is a Class B product based on the standard of the Voluntary Control Council for Interference
from Information Technology Equipment (VCCI). If this is used near a radio or television receiver in
a domestic environment, it may cause radio interference. Install and use the equipment according
to the instruction manual.
Warning
19841