Alcatel-Lucent 7330 - Figure 6-2 States Management Window with ONT Status Sub-Option Shown; Figure 6-3 Main Menu

6 — ONT management using an ONT interface
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 6-7
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
Window and status bar
Each main option opens a window with one or more sub-options as tabs. The window
always opens with the first sub-option preselected. For example, Figure 6-2 shows
the States Management window with the ONT status sub-option preselected.
Figure 6-2 States Management window with ONT status sub-option shown
To select another sub-option you must click on the applicable tab. The content of the
window changes to reflect your new selection. A status bar at the top of the window
displays information about the current state of the window. A Refresh button at the
bottom of the window refreshes the contents of the window with the current settings
for the ONT.
CLI interface
The CLI interface is menu-driven, and consists of two menus: the main menu and a
secondary menu. Each menu contains a number of options from which you can
choose. To navigate to the secondary menu, you must choose option 8. More options
from the main menu. Figures 6-3 and 6-4 show the main and secondary menus.
Figure 6-3 Main menu
Main menu
===============
1. Enter SLID in volatile mode
2. Enter SLID in permanent mode
3. Enter SLID in registration mode
4. Retrieve SLID
5. Clear SLID
6. Retrieve ranging state
7. Retrieve optical level
8. More options
9. Log out
Enter choice :