Alcatel-Lucent 7330 - Table 1-2 Package a ONT Considerations and Limitations

1 — ONT and MDU overview
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 1-9
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
Package A ONT considerations and limitations
Table 1-2 lists the considerations and limitations for Package A ONTs.
Table 1-2 Package A ONT considerations and limitations
H B-0404-A 7 G.984.3 compliant AES with
operator enable/disable on per
port-ID level
802.3 compliant
10/100/1000BASE-T Ethernet
interfaces using RJ-45 ports
four E1/T1 interfaces using RJ-48C
ports
MEF-8 packetization for TDM
transport over GPON
subscriber location ID (SLID)
IP video with multistage IGMPv3 or
IGMPv2 snooping
up to 64 video multicast streams
shared by 4 GbE ports
G.984.3-compliant multicast using
a single GEM Port-ID for all video
traffic
See Package H ONT
considerations and
limitations
Package
type
ONT or MDU
mnemonic
See UDS
chapter
Features and functions Considerations and
limitations
(6 of 6)
Considerations and limitations
No support for per VLAN protocol downstream tagging mode
In SVLAN cross-connect tunnel mode:
• use non-overlapping pbits since the use of the same pbits on two or more VLAN ports results in
a mismatch alarm
• downstream frames sent with a single tag normally sent out on the user-side as untagged, will
instead be sent as priority tagged
When using CVLAN translation, or when the same queue is used for multiple pbits, the highest pbit
value in the queue in the downstream direction will be selected to stomp the pbit in the packet
Simultaneous configuration of a CVLAN port and an S-Tunnel on the same UNI will only be supported
if these services are provisioned with non-overlapping pbits
The same VLAN port must be used when employing both protocol-based VLAN for PPPoE and
IPoE-based VLANs
When the VLAN is translated, the pbit value must be modified and the highest pbit value is mapped
to that GEM port
When more than one Ethernet port is in VLAN translation mode, or set to flexible mode with IGMP
channels created, the USERSIDE VLAN IDs of those services are different. All downstream multicast
packets will be tagged on the UNI port with VLAN ID of 4094
Maximum use of multicast on 1 Ethernet port at a time
For C forwarder and S+C CC forwarder, if the VLAN port uses regenerated profiles or regenerated
pbits, then the downstream traffic can only flow with the derived pbits
(1 of 2)