Alcatel-Lucent 7330 - Table 1-1 Onts and Mdus General Descriptions Per Package Type

1 — ONT and MDU overview
1-4 March 2011 Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
ONT Product Information Guide Edition 01 3FE 54199 AAAA TCZZA
• network demarcation for all services
• PON reach capacity: minimum 18.6 mi (30 km) and maximum 37.3 mi (60 km)
depending on the optical budget supported by the LT card used, the PON reach
specified based on network deployments, and the losses of optical fiber,
connectors, and splitters, and so on.
Table 1-1 lists the ONTs and MDUs categorized into package types and describes
the specific features, functions and limitations.
Table 1-1 ONTs and MDUs general descriptions per package type
Warning — Existing ONTs that use 7342 ISAM FTTU releases older
than R04.06.xx and R04.07.xx must be upgraded to use R04.00.10
software while assigned to a PON ID value smaller than 64. For this
purpose, if split ratios larger than 1:64 are being deployed, you may
choose to set aside the first PON ID as a staging point.
Package
type
ONT or MDU
mnemonic
See UDS
chapter
Features and functions Considerations and
limitations
A I-010G-A
I-020E-B
I-020E-H
I-020G-F
I-220E-A
I-241G-A
O-421E-B
8
10
10
10
13
14
22
AES with operator enable/disable
per port-ID level
Single mode fiber and use 2x5 SFF
SC/APC optical port
Optical budget of 28 dB (without
FEC) and an Rx optical sensitivity
of -27 dB
See Package A ONT
considerations and
limitations
FEC is not supported
on the following
ONTs:
• I-020E-B
• I-020E-H
• I-020E-B
• O-421E-B
(1 of 6)