Alcatel-Lucent 7330 - Figure 6-17 Main Options in the Web-Management System Window; Figure 6-18 Ranging State Window

6 — ONT management using an ONT interface
6-36 March 2011 Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
ONT Product Information Guide Edition 01 3FE 54199 AAAA TCZZA
Procedures using HTTP interface
The following procedure provides the steps to check the ranging state of an ONT
using the HTTP interface.
Procedure 6-21 To check the ranging state of an ONT
1 Ensure that the ONT is connected to the GPON.
2 From the Web-Management System window, click on the States Management
tab, as shown in Figure 6-17.
Figure 6-17 Main options in the Web-Management System window
The ONT status window opens with the ONT states and their current status, as
shown in Figure 6-10.
3 Click on the Ranging tab. The Ranging State window opens with the current
ranging state, as shown in Figure 6-18.
Figure 6-18 Ranging State window
where the ranging states are described in Table 6-8
4 Click on the Refresh button to refresh the contents of the window.
5 STOP. This procedure is complete.
Procedures using CLI interface
The following procedure provides the steps to check the ranging state of an ONT
using the CLI interface.