Alcatel-Lucent 7330 - Page 226

5 — VoIP overview
5-26 March 2011 Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
ONT Product Information Guide Edition 01 3FE 54199 AAAA TCZZA
password A password that is associated with the
AOR in the service provider domain
that is identified by the realm
identifier and is used in the
authentication of the user agent. This
is a string of up to 99 characters and is
an optional parameter.
Y Y All Yes Defined in
authentication
security method
PASSWORD using
TL1 using
ed-ontvoiceport
sip
CLI using
password
using
configure voice
ont
voice-sip-port
contact_uri_use
r
The user name portion of the contact
URI that represents the port on behalf
of which the user agent acts. The user
name of the contact URI is the value of
the contact_uri_user property. The
host value portion of the contact URI is
the numeric IP address of the user
agent. The contact URI is registered
against the AOR. This is a string of up
to 99 characters and a required
parameter. The FTP XML name of this
parameter is shown as ContactURIUser.
When the string autofill is used, this
keyword substitutes a new
contact_uri_user value, taking the
form:
CLIENTID + PORT#
where
CLIENTID is the TL1 and OMCI
configured value for CLIENTID
PORT# is the numeric port value, from
1 to n, where n is the numeric port
number for the POTS line
The CLIENTID and PORT# values are
concatenated, with no white space or
other delimiters between them
For other devices, the contact URI is a
“sip” URI whose user name is the value
of the contact_uri_user property and
whose domain is the FQDN of the user
agent, if available, otherwise the
numeric IP address of the user agent.
The Contact URI shall be registered
against the AOR.
YYPackage
A, B, H
only
No,
USERAOR
parameter
is used
N/A
primary_identity Specifies up to 10 identity data sets
may be associated with a single voice
line. If more than one data set is
specified, only one should be specified
as the primary identity. The primary
identity is the one to be used in
outgoing calls and subscriptions from
the line with which it is associated. If
more than one identity data set has
this property set to true/1/yes or if
none does, the voice client may use
any of the configured identities. The
default is false/0/no.
YYAll
except
package
C, D,
and E
No, value
is derived
from
FTP/defau
lt line
profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 and CLI
parameters
(2 of 2)