Alcatel-Lucent 7330 - Page 231

5 — VoIP overview
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 5-31
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
enable_rfc2833 Indicates whether voice activity
detection is enabled for voice
encoding. In order for DTMF tones to be
encoded in RFC 2833 packets, there
must be SDP negotiation and
agreement at both ends of the bearer
channel. The ONT or MDU will offer
RFC 2833 or include it in an SDP
response only if the enable_rfc2833 is
set to yes. This is a string containing a
value of “yes” or “no.”. The default
value is “yes.”
When set to ‘far_end_symmetry”,
during SDP negotiations of the RFC
2833 payload type, the ONT offers the
configured
dynamic_codec_payload_map_entry
value for RFC 2833. However, if the
ONT receives an answer to an offer
with a different payload type, the ONT
uses that payload type for both the
sending and receiving of RFC 2833
packets.
ONTs will explicitly include the SDP
direction attribute of sendrcv when the
current call connection is in a 2-way
conversation.
YYAll Yes TL1 using
OOBDTMF using
ent-profile-voip
media
CLI using
outofband-dtmf
using
configure voice
ont
voip-media-prof
enable_vad Indicates whether voice activity
detection is enabled for voice
encoding. This is a string containing a
value of “yes” or “no.” The default
value is “no.”
YYAll Yes,
always
defined in
first order
of silence
suppressio
n used
TL1 using
SILENCE1ST
using
ent-profile-voip
media
CLI using
silence1st
using
configure voice
ont
voip-media-prof
packetization_in
terval
This parameter controls the
packetization rate which each line of
the voice client (ONT or MDU) will use
in the offer/answer SDP messages for
the RTP packet rate it requests to
receive. The units are milliseconds
between successive frames. The voice
client can offer a subset of the range of
values of 10 to 30 (10, 20, 30 are
supported). The value actually used
will be rounded to the nearest
supported value. The default value is
10 when using FTP download and 20
when using iConfig to configure SIP.
YYAll Yes,
always
defined in
first order
of packet
period
selection
used
TL1 using
PERIOD1ST using
ent-profile-voip
media
CLI using
pkt-period1st
using
configure voice
ont
voip-media-prof
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameter
(2 of 4)