Alcatel-Lucent 7330 - Page 243

5 — VoIP overview
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 5-43
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
allow_unmatched_n
otify
This parameter governs behavior
to allow a NOTIFY with full dialog
headers (indicating that they are
part of a dialog) to be accepted by
the ONT that does not match a
known SUBSCRIBE dialog. The
contents of such an unmatched
NOTIFY will be ignored. The
default is “no”, meaning that a
NOTIFY with full dialog headers
must match a known SUBSCRIBE
dialog or a 481 error will result. If
the parameter is set to yes, the
contents of such an unmatched
NOTIFY will be ignored.
This parameter should not be set
to “yes” if implicit NOTIFY
messages are expected from the
softswitch (for example, no
SUBSCRIBE is performed).
For other devices, the value is no
and cannot be changed.
YYPackage
A, B, H
only
No, value is
derived
from
FTP/default
line profile.
N/A
rfc2833_symmetric This parameter governs the SDP
offer/answer processing related to
the payload type to use with
RFC2833. If this parameter is set to
“yes”, then it means that the same
payload types will be used for both
send and receive RFC2833 packets.
The payload type to be used will be
based on the SDP offer or answer
from the ONT. If this parameter is
set to “no” then the payload types
to be used for send and receive
RFC2833 packets are set according
to the rules in RFC3264 section 5.
If this parameter is set to
“far_end_symmetry”, the same
payload type will be sent for both
send and receive RFC2833 packets.
The payload type to be used will be
based on the SDP offer or answer
received from the far end of the
call. The default is “no”
Y Y All No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(11 of 23)