5 — VoIP overview
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 5-65
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
Each VoIP client is provisioned with at least one set that includes a realm identifier,
username, and password (shared secret). The information is also stored on the
network servers.
5.9 VoIP call statistics
VoIP call statistics are gathered for the last incoming or outgoing call on each POTS
port configured for VoIP on some ONTs. Up to 32 previous call statistics are
supported individually. VoIP call statistics are not supported on package C and D
ONTs.
An RTCP failure alarm is raised at the P-OLT if RTCP packets are not received
during a VoIP call.
Statistics collection
VoIP call statistics for the last incoming or outgoing call are retained at the ONT.
You can view the statistics from a management session with the P-OLT using TL1
or the EMS interface.
Collection of call statistics occurs when a bearer channel is established. If multiple
bearer channels are established during the course of a single call, such as if call
waiting occurs, then only the data from the last disconnected bearer channel is
retained in the ONT.
Table 5-15 lists the VoIP call statistics that are collected.
Table 5-15 Collected VoIP call statistics
Note — Call record log statistics are created only when a dialog
progresses to an RTP session. Inbound no-answer calls are not logged
because an RTP session is not configured while outbound calls are
being logged.
Type Description Statistic Format/unit
Date
(1)
The date when the call was initiated. This is determined at
the start of ringing when terminating a call (incoming), or
when going off-hook for the originating call (outgoing).
DATE YY-MM-DD
Example: 06-01-16
Time
(1)
The time when the call was initiated. This is determined at
the start of ringing when terminating a call (incoming), or
when going off-hook for the originating call (outgoing).
TIME HH-MM-SS
Example: 13-30-02
Duration The duration of the call is recorded as an integer in seconds.
For a call origination, the duration starts at the initial
off-hook and stops when the call ends with on-hook. For call
termination, the duration starts when ringing is applied to
the line, continues when the line goes off-hook, and stops
when the call ends with on-hook.
DURATION seconds
Called number
(2)
For outgoing calls, the called number is the digits dialed by
the subscriber.
For incoming calls, the called number is the identity of the
subscriber line terminated at the ONT that is receiving the
call.
CALLEDNO a string of up to 25
alphanumeric
characters
(1 of 2)
To Next Page
Loading...
