Alcatel-Lucent 7330 - Page 389

Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 NTP 104-1
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
NTP 104 — Replace an I-010G-A indoor
ONT
Purpose
This DLP provides the steps to replace an I-010G-A indoor ONT.
General
You must issue TL1 commands at the P-OLT before you replace an I-010G-A indoor ONT
at the subscriber site, and again before you can verify the subscriber services.
Prerequisites
The prerequisites are:
• network management access or craft port access to the P-OLT that supports the
I-010G-A indoor ONT to be replaced.
• serial number of the replacement I-010G-A indoor ONT.
• Ensure that any debugging sessions are disabled. You can re-enable debugging after
the procedure is complete.
For information about TL1 command syntax, see the operations and maintenance
documentation for the OLT.
Required tools
The required tools are:
• wire strippers
• #2 Phillips screwdriver
• fiber optic splicing tools
• RJ-45 cable plug crimp tool