NTP 104 — Replace an I-010G-A indoor ONT
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 NTP 104-3
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
10 Make the fiber optic connection as shown in Figure NTP 104-1.
11 Verify the ONT LEDs, voltage status, and optical signal levels (DLP 120).
12 Activate and test the services (DLP 121).
13 STOP. This procedure is complete.
Warning — Be careful to maintain a bend radius of no less than 1.5
inches (3.8 cm) when connecting the fiber optic cable. Too small of a
bend radius in the cable can result in damage to the optic fiber.
To Next Page
Loading...
