Alcatel-Lucent 8212 - Battery Charging and Autonomy

8212 DECT Handset - SIP User manual
8AL91447ENAAed01
10/32
2.2 Charging your telephone battery
2.2.1 Charging the battery on a single charger
Put your phone on its support. Plug the USB cable into a 5V socket (AC/DC
adaptor, computer, …).
The AC/DC adaptor is not provided with the set. Please contact your
provider for a recommended AC/DC adaptator.
You can configure how the handset behaves when it is installed on the
charger using the settings menu. Refer to the chapter on configuring your
telephone: Adjusting your telephone functions.
2.2.2 LED
• Green steady: the phone is on the charger and the battery is fully charged.
• Red steady: the phone is on the charger and the battery is charging.
Recharge your telephone battery regularly. The telephone can be on or off when recharging the battery.
If the telephone is to remain unused or out of its charger for several weeks, remove the battery and
store it separately.
The battery charging time is less than 10 hours.
2.2.3 Autonomy of your telephone
On standby in the radio coverage zone
Up to 113 hours.
In continuous conversation
if the display fails to light up or the battery icon
is flashing, recharge the battery.
2.3 Switching on your telephone
• Press the switch on/off key (long press).
• Your telephone is switched on.
If the display fails to light up or the battery icon is flashing, recharge the battery.
If the radio reception icon doesn't appear on the telephone display:
• Check that you are in an area covered (if you are not, move close to a radio access point).
• Check that the telephone is properly installed in the system (consult the PABX manager).
If the display indicates: 'Auto install ?', see paragraph 'Registering the telephone' or contact your
installation technician.
2.4 Switching off your telephone
• Press the switch on/off key (long press).
• Confirm: Yes.
• Your telephone is switched off.