Alcatel-Lucent 8212 - Getting Started: Handset Setup; Battery Installation and Removal

8212 DECT Handset - SIP User manual
8AL91447ENAAed01
9/32
2 Getting started
In order to have a fully operational 8212 DECT Handset, make sure that you have the following items:
• 8212 DECT Handset.
• 2 rechargeable NiMH batteries AAA 600mAh 1,2V.
• A single charger.
2.1 Installing the battery in the telephone
2.1.1 Installing the battery in the telephone
• : Push the cover towards the back of the phone until the
cover is unclipped.
• : Lift up the cover.
• Use the plus ('+') and minus ('-') guides in compartment to insert
the batteries in the proper direction. Insert the minus ('-') end
first and push to place the battery.
• : Replace the cover.
• : Push the cover until it is clipped.
When inserting the batteries, the phone will turn on and the charge management is reset.
2.1.2 Removing the battery from the telephone
• : Push the cover towards the back of the phone until the
cover is unclipped.
• : Lift up the cover.
• To remove the battery, remove the plus ('+') end first.
•