Alcatel-Lucent 8212 - System Management and Handset Configuration; Deregistering from a System; Power Mode and Economy Mode Settings

8212 DECT Handset - SIP User manual
8AL91447ENAAed01
27/32
4.4 Deregister
• Access MENU.
• Install
• Deregister
• Enter the PIN Code (default code: 0000).
• Apply (Ok).
• Select the network.
• Delete registrat.?
• Yes (No: to cancel).
• Apply (Ok).
• Return to idle.
4.5 Power mode
You are advised not to select the 50 mW power mode unless required. The '50mW power mode' is
intended for hazardous sites such as nuclear plants where it is requested that emissions do not exceed
the maximum value.
The change of mode is made according to the connected system. When connected to a system, the
handset will use the defined mode on this system. If the handset is out of the coverage range, make sure
that the desired system is selected before making the change. If the handset was configured to connect
to any available system, you can restore this configuration after changing the power mode (Auto.
select).
• Access MENU.
• Install
• Power mode
• Enter the PIN Code (default code: 0000).
• Apply.
• Select the power mode using the corresponding softkeys: Normal / 50 mW power.