Getting started
2
11
Other
2.1
Installing the battery in the telephone
• Installing the battery in the telephone
• To remove it
2.2
Charging your telephone battery
• How to dock your phone on the desk support
If the belt clip is installed,
you must lift it up and
maintain it in this position
during the battery
installation or
replacement.
You can also turn the belt
clip counterclockwise.
Lift up the cover. Position the battery
connectors side as
shown in the drawing
(A). Terminate the
installation of the
battery in its
compartment by
pressing as shown in
the drawing (B).
Replace the cover.
If the belt clip is installed,
you must lift it up and
maintain it in this position
during the battery
installation or
replacement.
You can also turn the belt
clip counterclockwise.
Lift up the cover. Remove the battery from its compartment as
shown in the drawing.
Put your phone on its support. Plug the USB cable into the 5V socket of the desk support. Plug the
other end of the USB cable into the AC/DC adapter. Plug the adapor into the mains power supply.
To Next Page
Loading...
