12
• How to dock your phone with the USB cable
LED
• Green steady: the phone is on the charger and the battery is fully charged
• Red steady: the phone is on the charger and the battery is charging
Recharge your telephone battery regularly. The telephone can be on or off when recharging the battery. If the
telephone is to remain unused or out of its charger for several weeks, remove the battery and store it separately.
2.3
Switching on your telephone
If the display fails to light up or the battery icon is flashing, recharge the battery. ;
If the radio reception icon doesn’t appear on the telephone display :
• Check that you’re in an area covered (if you’re not, move close to a radio terminal).
• Check that the telephone is properly installed in the system (consult the PABX manager).
Switching off your telephone:
Press the switch on/off key (long press).
Plug the USB cable into the USB port of your phone. The other end of the
USB cable can be plugged into the AC/DC adapter or into a computer USB
port.
You can also charge your phone from any USB plug, such as a computer USB plug. However, the
charging time is longer than charging with the AC/DC adapter.
The battery charging time is less than 3 hours. The charging time is longer if charging through the
USB plug from a device other than the AC/DC adapter.
Autonomy of your telephone
On standby in the radio coverage zone: up to 200 hours
In continuous conversation: up to 20 hours
Switch off the telephone before changing the battery.
Your telephone is switched on
Press the switch on/off key
(long press)
If the display indicates: "System 1 Auto install ?", see paragraph "Registering the telephone" or
contact your installation technician.
To Next Page
Loading...
