Registering the telephone
8
30
Other
8.1
Registering the telephone on a system for the first time
For the mobile telephone to function, it must be registered on at least one Alcatel-Lucent or GAP system
(registration operation).If when first switched on the display indicates: "System 1 Auto install ?" your telephone
has not been registered on any system; consult your installation technician or proceed as follows:1. Prepare
your system for registration (see system installation guide).2. When the system is ready, the station always
displays the starting screen:
• Registration can begin
a- If the system does not use an AC code
b- If the system uses an AC (authentication code)
The registration operation can last up to 2 minutes.
If the operation has been done correctly (subscription accepted), the telephone is ready to be used and
the radio reception quality icon is displayed.
If the registration operation has not been successful, the station proposes launching the subscription again.
8.2
Registering the telephone on other systems
The telephone can be declared on several systems (maximum of 5).
Note: the input is usually reserved for use with your main Alcatel-Lucent system. You can select the other inputs
to register the telephone under another system (Alcatel-Lucent or other system).
To make a new registration, when the telephone has already been registered on one or more systems, proceed
as follows:
1. Prepare your system for registration (see the system installation manual or consult your installation manager).
• auto install?
• confirm
• launch subscription
•register
• enter the pin code (0000 by default)
• apply
• select a system (it is recommended that the first empty system is selected)
• enter park code
• apply
• enter access code
• apply
• select power mode (your are advised not to select the 50 mw power mode unless
required. the "50mw power mode" is intended for hazardous sites such as nuclear plants
where it is requested that emissions do not exceed the maximum value.)
Utilization of the telephone in GAP mode can lead to functional limitations for which no claims will
be considered under the terms of the warranty.
To Next Page
Loading...
