Precautions for use
7
Operating conditions
This approved DECT telephone is intended to be used with an Alcatel-Lucent cordless PBX. The following
conditions must be respected, notably concerning the use of radioelectric frequencies:
Changes or modifications to the equipment not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
To limit the risk of interference, people with pacemakers must keep the wireless telephone away from their
equipment (minimum distance of 15 cm/6 inches)
It is recommended to follow the standard acceptance procedures before using this equipment in human safety
critical areas (hospitals...).
DECT equipment can only be used to establish links between fixed points if these links are temporary and the
equivalent isotropically radiated power at the antenna is less than 250 mW.
The conditions of access to a DECT equipment telepoint network shall be stipulated by contract with the operator
of the authorized telepoint network concerned.
Do not expose your telephone to severe conditions (rain, sea air, dust, etc.).
Switch off the telephone before changing the battery.
You must not switch on or use your telephone near gas or inflammable liquids.
The handset includes magnetic elements that may attract sharp metallic objects. To prevent injury, before each
use ensure sharp metallic objects are not stuck to the earpiece.
There is a danger of explosion if the battery is replaced incorrectly. Use only recommended battery : Alcatel-
Lucent 3BN67332AA (China Shenzhen DRN Battery Co. Ltd. RTR001FXX / China Effort Limited CE-MB206-5C-
XX - Li-ion 3.7V 1100mAh 4.1Wh).
The mains power socket used must be close to the charger/holder and easily accessible, so that it can be used
as an "on/off" facility.
Battery charge : Charge the battery for about 16 hours before initial use.
Use only 8232 DECT Handset charging units: : 8232 DECT Handset Desktop charger (3BN67331AA), 8232
DECT Handset Desktop charger PSU (SALOM SSW-2374, Friwo FW7712-/FW7713/XX, Ten Pao
S005SV0500100 / S005SB0500100). You can charge the device by connecting it to a USB 2.0 port (type A). Use
only the cable provided with the 8232 DECT Handset Desktop Charger (USB "A" plug).
The labels and icons presented in this document are not contractually binding and may be modified without prior
warning.The labels and icons displayed on your phone depend on the system to which you are connected and may
differ from those specified in this document.
To Next Page
Loading...
