User Manual
8AL91433ENAAed01 54 /70
Phone auto test
This feature depends on your system.
The auto test of the phone is a quick hardware test of the sound, the display and the LEDs. It lets the user
do the first tests directly from the desktop.
• The phone is switched on and connected.
• Reach the 'Menu' page.
• Settings Options Phone test
• Auto test has started.
• To stop the auto test.
Access to administrator configuration (only available in IP mode)
Your administrator can access to the phone configuration. Depending on the system configuration, an
administrator password is requested to access this menu.
This menu is only available when the desk phone is running in IP mode.
In this configuration menu, use this icon to go back.
• Use one of the following:
o Open the user local menu: reach the 'Menu' page Settings Phone Local Menu
Config.MMI.
o Connect your desk phone to the network (and plug in the power jack if you are using an
external power adapter). When the desk phone displays the 'Step 2' during the boot,
repeatedly press the '*' and '#' keys in succession until a menu is displayed.
• This section allows the administrator to set or consult:
o IP parameters: IP Parameters IP Status
o DHCP option: IP Parameters IP Config
o Phone memory: IP Parameters Memories
o Used network (wired or wireless): Network
o Wired network configuration: Network Wired network
o Wireless network configuration: Network Wireless network
o VPN configuration: VPN
o Security: Security
o Software information (version, run mode): Software infos
o Hardware information (MAC, CPU): Hardware infos
o Software update mode: Software infos Upgrade
▪ Enable software upgrade: upgrade via network (system).
▪ Upgrade from USB now: use a USB drive to upgrade the software when you
restart the desk phone.
o Factory configuration: Reset to Defaults
To Next Page
Loading...
