For IP Touch 4018EE phone, the available binary files are:
– noesip4018 (application)
– datsip4018 (resources including the ringing melodies)
These binary files are downloaded from the server whose IP address is either retrieved from a
DHCP server (dynamic configuration) or defined in the set itself (static configuration).
3.3.3.
Selecting the downloading mode
Binary (noesip40x8 and datsip40x8) and Configuration files (sipconfig.txt and
sipconfig-MacAddress.txt) are downloaded from the server defined via DHCP or the set
itself.
They can be downloaded via 3 methods (IMPORTANT, the used method is under customer IT
Management policy):
– Either TFTP
– or HTTP
– or HTTPS. HTTPS guarantees the authentication, based on TLS client authentication
mechanism, and the confidentiality of the files. This download requires certificates.
When downloading fails, the parameters stored in flash memory of the set are used.
3.3.4.
TFTP
Method 1 - Manual
1- Power on the phone.
2- At the phase 2/5 network setup, press the "i" key and just after the "#" key.
3- ‘MAC address’ menu appears.
4- Scroll down to ‘IP parameters’.
5- Press OK.
6- Set following parameters (press OK to select or to change value).
IP Mode: Static
IP @: @ you want to give to your SIP phone
Subnet: Subnet mask
Router: Default gateway of your subnet
DL scheme (download scheme): TFTP
Use default port: Yes
DL @: TFTP Server @
DL port: 69
7- Press OK to save.
Warning: no administrator action within 30 seconds in the configuration menu will automatically
lead to quit this menu.
To Next Page
Loading...
