8/91
1.2.2 Connect the device
Please read safety instructions first.
Connect the handset (4) if it is not connected (your phone is usually provided with the handset
connected).
If your desk phone is correctly configured, you can connect it to the network (2). If your desk
phone is not powered by PoE (Power over Ethernet), you have to plug the power adapter to
the USB-C connector (1) and connect it to the AC power supply. The power adapter is sold
separately. For more information, contact your installer or administrator.
For more details, please consult the section: Description of the connectors.
1.2.3 Install a comfort wired handset
Your phone is provided with a connected handset. If you have to replace it:
• Plug-in the wired handset to the appropriate
connector (refer to phone description).
• Make sure you position the cable
correctly in the compartment intended
for that purpose.
1.3 Multiple SIP accounts
Your phone supports multiple SIP accounts. Your administrator can declare up to 8 SIP
accounts. A default account is used for calls unless you select the relevant account prior the
call. When you have programmed some function keys, you can associate a SIP account to the
key.
It is recommended to programme a key for each SIP account in the main page, as a line key.
Then the status of the account is displayed on the homepage. The key of the SIP account
receiving an incoming call is blinking.
To Next Page
Loading...
Need help?
General
