8
OBTAINING A NETWORK ADDRESS
Connecting to a network with DHCP
See “Check IP address” under “USING THE WEB INTERFACE” on page 6.
Connecting to a network with static IP addresses
You need the IP address, host name, domain, netmask, gateway, DNS 1, and DNS 2.
The host name can be set freely. The domain and secondary DNS can be left blank.
Press MENU and select SETTINGS > ADVANCED (6,2).
Enter the PIN code.
The default code is 1234.
Select NETWORK (2)
Select STATIC IP.
Enter values for the IP ADDRESS.
Enter three digits (begin with 0 if necessary), press OK, enter three digits, and so
on.
Enter HOST NAME
Default is kt300ip.
Enter DOMAIN
Enter NETMASK
Enter GATEWAY
Enter DNS 1
Enter DNS 2
The display shows DONE.
LOGIN
See “Login” under “USING THE WEB INTERFACE” on page 6.
INSTALLATION
To Next Page
Loading...
Need help?
General
