Alcatel-Lucent OmniTouch 4135 IP - Using the Web Interface (Continued); Web Interface Call List Checking

38
Reset conguration
If you have forgotten the Admin PIN code, the only way to reset it to default is to do a
hard factory reset. This is the same as the Factory reset in the system menu (MENU >
SYSTEM > FACTORY RESET).

This erases all settings including account information and contacts!

Disconnect the power supply cable. Note that this is the same as the network cable
if the phone uses Power over Ethernet.

Press and hold the MENU button while you connect the cable again (i.e. starts the
OmniTouch 4135 IP). Hold the button pressed until the SYSTEM RECOVERY menu
is shown on the display.

You can press any other button than 1, 2, or 3 to start the phone without resetting.

Press 1 to select Reset conguration and conrm with OK.

Upgrade to the latest version of the software when the phone has started and redo
the setup of account and other settings (see page 9).
Restore rmware
This replaces the current software with the one supplied with the phone. All settings are
erased.

Disconnect the power supply cable. Note that this is the same as the network cable
if the phone uses Power over Ethernet.

Press and hold the MENU button while you connect the cable again (i.e. starts the
OmniTouch 4135 IP). Hold the button pressed until the SYSTEM RECOVERY menu
is shown on the display.

You can press any other button than 1, 2, or 3 to start the phone without restoring
the rmware.

Press 3 to select Restore rmware and conrm with OK.
All content in the phone’s memory is erased and the rmware supplied with the phone is written
to the memory.

Upgrade to the latest version of the software when the phone has started and redo
the setup of account and other settings (see page 9).
HARD SYSTEM RECOVERY