Getting Started Your First Login Session
OmniSwitch 6900 Hardware Users Guide June 2020 page 2-9
Setting IP Address Information for the EMP
IP address can be set via the Ethernet Management Port (EMP). To connect to the switch through the EMP
Ethernet connection, use the default address below or change the port’s IP address.
Note. You should be connected to the switch via the console port before attempting to change IP
address information.
To change the default IP and mask, use the ip interface command. For example:
-> ip interface emp address 168.22.2.120 mask 255.255.255.0
Verify your settings using the show ip interface command. See the OmniSwitch AOS Switch Manage-
ment Guide for additional information regarding EMP port addressing.
Note. Although you have configured the EMP with valid IP address information, you will not be able to
access the switch through this port (i.e. TELNET, FTP, HTTP, SSH or SNMP) until you have unlocked
these remote session types. See “Unlocking Session Types” on page 2-10 for more information.
Default EMP IP Address 192.168.1.1
Default EMP Mask 255.255.255.0
To Next Page
Loading...
Need help?
General
