AFTER SALES SUPPORT
(toll free)
e-mail: info.aldi@positecgroup.com1300 889 028
80V Lithium-Ion 20” Brushless Lawn Mower
MODEL: №. 10094 • 08/2019 • CLM80XA
17
Adjusting the cutting height (See Fig. F)
WARNING! Switch o the mower, and wait
for blade to come to a complete stop. The
blades continue to rotate after the machine is
switched o, a rotating blade can cause injury.
CAUTION: Do not touch rotating blades.
The lawn mower has one cutting height adjustment
lever (13) to easily adjust the cutting height. There are
6 height settings.
NOTE: Always try to adjust the cutting height of the lawn mower while
positioned on the area of grass you plan to mow.
It is recommended to start on a higher setting and mow a trial area of
lawn before deciding on the nal cutting height position. Then readjust if
necessary.
1) To increase the cutting height pull the cutting height adjustment lever
(13) outward towards the wheel (11), and move it up a notch, towards the
rear of the lawn mower.
2) To decrease the cutting height pull the cutting height adjustment lever (13)
outward towards the wheel (11), and move it down a notch, towards the motor.
3) After adjustment, ensure the lever (13) is fully located in the selected
notch.
Charging the battery pack (9)
- Checking the battery condition (See Fig. G1)
Before charging, press the battery power indicator
light button (25). The green LED light will illuminate
to show the remaining battery power. If only one LED
light ashes, the battery pack (9) needs charging.
Light condition Power Status
1 LED light ashes <10%
1 LED light illuminate 10~30%
2 LED light illuminate 30~60%
3 LED light illuminate 60~90%
4 LED light illuminate
≥90%
F
G1.
To Next Page
Loading...
