ALDI FERREX CLM80XA - Operating the Lawnmower; Starting, Stopping, and Operation Modes

AFTER SALES SUPPORT
(toll free)
e-mail: info.aldi@positecgroup.com1300 889 028
80V Lithium-Ion 20” Brushless Lawn Mower
MODEL: №. 10094 • 08/2019 • CLM80XA
19
Installing and removing the battery pack (9)
1) Open the battery housing cover (8), insert the battery pack (9) into the
battery housing of the mower with sucient force. Be sure to fully engage the
battery pack (9) in place. (See Fig. H1)
2) Insert the safety key for battery pack (20) into the key slot beside the
battery pack (9). (See Fig. H2)
3) To remove the battery pack (9), depress the battery release latch (26) upwards
and slide the battery pack (9) out from the battery housing. (See Fig. H3)
WARNING: The blade continues to rotate for a few seconds after the
machine is switched o. Allow the motor/blade to stop rotating
before switching “on” again. Do not rapidly switch o and on.
NOTE: Ensure your battery is charged before use.
Starting and stopping
-Starting
1) Install the battery pack (9) to the mower. Insert the
safety key for battery pack (20) into the key slot. Refer to
Installing and removing the battery pack (9).
2) Press the lock o button (18), then pull the start bar
(3) upward towards the upper handle (2) bar and keep it
in position to start the mower and also during use. (See
Fig. I)
3) Release the lock o button (18).
I.
Operation
H1. H2. H3.