26
Safety
j) Make sure that the saw blade is fitted in the correct direction
of rotation. Do not grinding wheels or wire brushes with the
table saw. If the saw blade is fitted incorrectly or accessories are
used which are not recommended, this could lead to serious
injuries.
Additional safety instructions
1. Only use a saw blade which has the external diameter and
hole diameter specified in the original operating instructions
(“Technical data” section).
2. Only use saw blades whose permissible maximum speed of
rotation is not lower than the maximum spindle speed of the
table saw and which are suitable for the material to be cut.
3. Only fit blades which are well sharpened and have no cracks or
deformations.
4. Faulty saw blades must be replaced immediately.
5. It must be possible for the blade to run freely.
6. Check the saw blade guard for damage and wear each time
before using the saw.
7. The saw blade guard must lower again automatically under its
own weight after each cut. The saw blade guard must lift when
the workpiece is pushed in the direction of the saw blade.
8. Damaged or faulty safety devices have to be replaced
immediately.
9. It is imperative to make sure that all devices which cover the saw
blade are in good working order.
10. Never dismantle the machine’s safety devices or render them
inoperative.
11. Refit all guards and safety devices immediately after you have
completed any repairs or maintenance work.
12. Keep the push stick or handle for a push block at the machine at
all times, even when you are not using them. Slot the push stick
Layout_F_TS_2000_1_UK_SPK7.indd 26Layout_F_TS_2000_1_UK_SPK7.indd 26 23.06.2020 14:29:3623.06.2020 14:29:36
To Next Page
Loading...
Need help?
General
